The T1 02.01.02 Complete Fuel System - Engine Bay Only is designed to be installed on the R35 Nissan GT-R, in conjunction with either the AMS 12-injector or Boost Logic 12-injector intake manifold. As is the case with any fuel system related work, all work should be performed by a qualified mechanic on a cool engine and it is advised to disconnect the battery as well. This kit mates to the OEM main feed/return lines in the engine bay, and does not address the fuel pump hanger in any way.



This engine bay image below gives a good representation of how the fuel system will look once fully installed. Note, the secondary rail is acting as the first fuel rail in the system now:


The F750 fuel filter is fed directly from the OEM feed line (larger of two hard lines on passenger side of engine bay), and the outlet line runs under the intake manifold alongside the valve cover in the center valley area before terminating at the rear of the secondary fuel rail:


Below you can see how the secondary to primary lines crossover in the center valley:


A detailed image of the fuel pressure regulator installed with all the lines routed and included mounting hardware/bracket. Note the orientation and routing of both banks to the regulator:


Detailed image of how the mounting bracket and hardware secure the fuel pressure regulator to the firewall. Please note, you will reuse both factory rubber grommets from the firewall mounted OEM fuel line bracket:


On the backside of the bank 1 primary rail, the ECA sensor will directly mount using the T1 EFI to ORB fitting: